Excalibur saw stand leveling feet problem

[Northerner]

does anyone know where to get the plastic or rubber feet for the
Excalibur stand? and please don't say from Excalibur cause there is
no way in H those are worth thirteen bucks each!

has anyone put something else on there table or know of some good
reasonably priced feet?

[tvman44]

How about a bolt and a couple of nuts.  A little troublesome to adjust but work well.

[jimbo]

Adjustable feet are supplied with the machine
Jimbo

[joey65746]

Your hardwaer store should have them they dont cost that much

[Northerner]

How about a bolt and a couple of nuts.  A little troublesome to adjust but work well.

that wouldnt cause any vibration would it.  

Adjustable feet are supplied with the machine

if they came with the machine i wouldnt be needing any but since i bought it used and it doesnt
have any, i thought i would make a post and hopefully get the help i originally asked for.

Your hardwaer store should have them they dont cost that much

thanks joey, if all else fails here i will see what they have.

[maritimer]

I put a set of Kreg wheels on mine.  My chair is to high for the saw and couldn't be lowered so we put a set of locking wheels on and works well.  My previous saw was a Dewalt and it sits higher so was perfect for the chair.

[ShadowB6]

I did the same as Maritimer. I put a set of 4 lockable wheels on my stand. What I enjoy most about that is that in nicer weather I cam wheel my saw outside of my shop into the open. the wheels are 6" in diameter and come from a Stryker hospital bed.

Mike