Author Topic: Req: push block pattern (Read 1366 times)

ex-28 · « **on:** January 08, 2012, 11:14:13 pm »

just wondering if anyone has any pattern around to make a push stick or block for use on table saw ? ,

greatlly appreciated , thanks

MIke

wsmith0896 · « **Reply #1 on:** January 12, 2012, 11:24:12 am »

This is what I use all the time on my tablesaw.

Fab4 · « **Reply #2 on:** January 12, 2012, 04:57:04 pm »

Hi Wade:
Thanks for the reply
I kept a copy
Fab4

Russ C · « **Reply #3 on:** January 12, 2012, 05:40:55 pm »

Sorry Wade, but that .doc contains a pattern made by someone else and cannot be posted here.

ex-28 · « **Reply #4 on:** January 12, 2012, 10:27:03 pm »

url's are ok i belive if your avble to post , thanks again .

Raptor66 · « **Reply #5 on:** January 13, 2012, 08:06:17 am »

There is a good one in the latest Wood magazine.

Russ C · « **Reply #6 on:** January 13, 2012, 08:29:40 am »

Here is one you can use. The smaller you can make the hole for the handle the better. It will make it stronger. Stay safe.

Jim Finn · « **Reply #7 on:** January 13, 2012, 10:06:17 pm »

Here are some I make. I make about 10 at a time from scrap because they are "consumable"

ex-28 · « **Reply #8 on:** January 13, 2012, 10:08:21 pm »

thanks for all the ideas all , really appreciate !

News: Had a couple issues with the forum today. 1/19/2017. I believe I have them corrected now. Let me know if you have any trouble. Thanks.