Thanks Torsten, I checked the video's out and did that, it cut it down by half, but going any further turning the motor and it starts to increase it again, so I got to find the happy medium. The only time i notice any trouble with it is doing a tight turn, then it will bounce if you dont hold the work very firmly. With a little time and trial and error I'm sure I'll sort it, either way it's a fantastic machine to use, it's quiet and vibration free except on full speed but thats my worktop vibrating (I dont have room for a seperate stand for it) so far I have only needed to use it on about 3/4 speed as it cuts fine at that speed. I'll let you know when I sort the blade movement problem.
