For Friends Church

[WigWag Workshop]

Good Day Folks!

Was wondering, if one of you kind folks can help me make a pattern with the attached picture.  Not sure if it should be a portrait type, plaque, or another type.  Would like it to be a little bigger than the picture, since my skills at cutting smaller letters are not on par yet. This is for my Co-Workers church, he is always very helpful, to the community, and I though i would be a nice jester.

Thanks in advance,

Steven

[Gabby]

Steven that should make a nice sign, I didn't see any floaters.
Do a search for "PostRazor" it is free and simple to use (always a plus) and will make it possible to print it as large as you want. It will print on several pages of paper that you will have to glue and or tape together. I prefer to glue and tape so that the sawdust doesn't get between the pages and also prevents it from flapping up and down with the blade.
Good luck,
Gabby

[Oges]

Here you go

[Russ C]

In the original picture Gabby the  three o's, a and d are all floaters if cut as a plaque. Nice job there Oges. 

[GrayBeard]

Oges...I had to look twice to see how you 'buried' the 'bridges'!

Nice way to adapt!

~~~GB~~~

[Gabby]

In the original picture Gabby the  three o's, a and d are all floaters if cut as a plaque. Nice job there Oges. 

You are right Russ, I blew right by them. Dirty glasses is my excuse. LOL
Gabby

[WigWag Workshop]

Thank You Oges!  Will post some pictures of the project.