Gift Card Holders

[dgman]

I have made about 35 so far. They are to be sold at two different shows this year. Woods used are Walnut, Cherry, Red Oak, Spanish Ceder, Ash and Sapele. All 1/8". I cut in stacks of four sides at a time, and four centers at a time. Used Flying Dutchman UR1 blades. I have not decided on price yet, but thinking in the ballpark of $8.

[Intarsia92]

Your Gift Card Holders turned out great, they should be big sellers. Good luck.

[Russ C]

They look great, nice work Dan. 

[beginner]

Good work Dan Thanks for sharing

[Chachi]

Those look awesome Dan thanks for the share.

[tux_linux]

*like*

[Chachi]

Torsten you need to stay off of Face book LMAOOOO (if you don't know what it is I will explain)

[DWSudekum]

Very nicely done Dan.  Thanks for sharing them with us.  8 - 10 would be a good price range for them.

DW

[tux_linux]

@ chacci
We should have a like button here

The idea for these card holders is still really brilliant to me - and Dan made them perfect. Another cause to make some of these.

[Oges]

Very nicely done.
I take it the little plastic gift card slides inside this?

[dgman]

Yes. And a ribbon or cord goes in the little hole to hold the card in.

[Reaper]

dgman, how do you make the space between the two sides?

[dgman]

dgman, how do you make the space between the two sides?

If you look at the pattern, It's a third piece of 1/8" that is cut out and glued in between the two outer pieces. http://www.stevedgood.com/giftcardholder.pdf

[Reaper]

dgman. Thanks for the help...Dave

[TripleB]

Those are pretty slick Dan, bet I know whats next