Why do I get so much tare out?

[shrimpmojo]

 I don't know why i get so much tare out when i cut oak ply. Even if i use tape and if i'm stack cutting. I'm also using reverse blades??

[UHMNL]

Most likely not enough tension. The blade should not move sideways more then 1/8". Also not enough speed and you do not let the blade do the cutting.
Don'tpush too hard into the blade.
FD Mike

[daneklund]

One other thought on the tear out is to try going down a blade size -i.e. if you are using a #7 try a #5 or even a #3 or #4 if you have them. 

[shrimpmojo]

Thanks for all your help.