This Indian was designed by our very own Russ back a couple years ago. I had a lot of fun cutting it. Started using the UR#5 blade and then the ur#3, but wasn't happy with the tight turns needed, so tried a UR#1 and Bingo. It cut so, so smooth and almost 100% accurate. Oh yea I stacked two using good ole Lowes quarter inch Red Oak. Its really only 3/16" thick. Anyway the bottom piece came out with very, very little fuzzies. I was impressed, so I finished it as if it were the top. You be the judge. I would love any and all Pros and Cons. Thanks .... Danny :+}