Author Topic: What do I do when the warped wood?  (Read 1000 times)

Offline frankorona

  • *****
  • Hero Member
  • Posts: 4030
  • Frankorona (Frank) (Crown)
    • View Profile
    • Frankorona?s workshop
What do I do when the warped wood?
« on: March 20, 2011, 07:26:51 pm »
Hello everyone
I know there are softwoods but are not yet available in my pocket.
In my search I found a wood called "pine ayacahuite"
The wood is easy to cut, is soft, but has two problems that I can not fix it.
1, is very brittle, any drop or excessive force is broken.
2 ? when I brushed and cut into the bar were fine, but over a few hours the wood is buckling.
How I can solve for the wood to warp?
Am I working with the right wood?
Would someone help me solve my problem.
thanks in advance and greetings from Puebla, Mexico

ArtCrafters

  • Guest
Re: What do I do when the warped wood?
« Reply #1 on: March 20, 2011, 08:43:57 pm »
If you can glue two pieces together face to face, make sure the end grain goes in opposite directions.  This should help with warping.

Denny in TN

Offline Rapid Roger

  • *****
  • Hero Member
  • Posts: 1468
  • Hutchinson, Kansas
    • View Profile
Re: What do I do when the warped wood?
« Reply #2 on: March 20, 2011, 10:03:15 pm »
Try laying it on a flat surface in your shop and put some weight or clamps on it to hold it down. Lay it as flat as you can for a few days and let it get accustomed to the air and humidity in the shop. This may help but it is no guarantee. You will just have to try it and see.
I have never heard of any wood that is so brittle that it breaks by being dropped. Are you sure it is not dry rotted? It doesn't sound like it would be good wood for scrolling or anything else.
Just my thoughts.

Rog
An ounce of responsablity is worth 10 pounds of state and fedral laws.

Offline Russ C

  • *****
  • Hero Member
  • Global Moderator
  • Posts: 8458
  • Central Florida - USA
    • View Profile
Re: What do I do when the warped wood?
« Reply #3 on: March 21, 2011, 07:55:24 am »
I agree with Roger. If you stack them make sure you put spacers between them.  8)
russ@simplywoodencreations.com

Keep The Blade On The Line.

 

SMF

Teknoromi