You are my everthing

[grampa]

Hope its of use.........Paul

[Chachi]

Once again Paul You have done it Amazing job thanks for the share I got my copy, You are the man <insert clapping smiley here>

[newfie]

Great pattern once again Paul,got my copy.
thanks Todd

[cameronj]

Thanks Paul.  My daughter and son-in-law will love it for our grandson.
Jim

[Bill P]

Wow.

Bill

[Russ C]

Thanks for sharing the pattern. Nice job. 

[pauley555]

outstanding,thanks again paul

[pokey]

Paul,

You are amazing with a fantastic talent. 

pokey

[Dawie]

Thanks a lot Paul. Couple of babies due this end, so I might just make this for one of them parents.
David

[Dobbo]

This one is Super.Just Great Neighbour across road
has just had a baby Boy.

[mrsn]

I just love this pattern!

[blue11811]

Hi Paul,
Newbe here you make nice patterns and great ideas.

Thanks

[wha]

Thanks for the great pattern. My wife has a baby shower to go to this week.
I cut this out of 1/2" maple and used up a lot of blades. The blades I used were
18tpi double tooth and 16tpi double tooth. Could this have been cut with different blade numbers. Thanks.

[dgman]

Hey Wha, welcome to the forum! Most folks would of done that pattern in 1/8" or 1/4" Baltic birch plywood, However 1/2" maple is doable. I would use a Flying Dutchman UR 3 or 5, or an Olsen #2R or 5R skip tooth blade. I don't know what sizes you used, but the ones I recommended above would work nicely.
Feel free to post a picture of the completed project!

[wha]

Thanks dgman next time I'll try it at 1/4". I did it at 1/2" because the wood I get is about 1" rough and to plane it to 1/4" I feel like I'm throwing half the board away. I'll have to get some of those blades at that size and try it.
The blades I used were Pegas blades Doubletooth #4 .012x.040x16TPI
and Pegas blades Doubletooth #2 .010x.033x18TPI .
Here is the finished project.