This is Steve?s pattern (Thank You Again Steve) of a light bulb vase. I used maple and blood wood for this cutout. This was actually cut from a cutting board that went bad. The cutting board chipped out when planned, and then warped, as it sat while I was trying to find something else to do with it. Well I found something to do with it, and it turned out so nice. I still haven?t put a single flower in it because I always buy the wife a dozen or more every month. Might have to down size so she can use it. This was actually a little hard to cut as both woods are very hard woods. However it was fun and came out nice.