How to get burn

[edward]

Just wondering how to get burn marks out of 1/2" oak, got the project finished and noticed a burn mark, tried sanding and still there, any suggestions.  edward

[BilltheDiver]

Perhaps you could re-cut the burned area taking off only a slight amount while running the blade at a lower speed?

[lanemaux]

I  think a scraper would be your friend in this case. Very controllable and removes only as much as needed. But that's just me, as I use scrapers a lot , some folk can't seem to get on with them.

[Brian Pardue]

I'm normally able to get the burn marks off of oak with my Dremel and a flat sanding disk, set on a slower speed.

[kardar2]

Just wondering how to get burn marks out of 1/2" oak, got the project finished and noticed a burn mark, tried sanding and still there, any suggestions.  edward

Just a lot of sanding. Do you use tape on your wood?
 I always put clear packing tape down the then blue painters tape then my pattern. I don't need to sand burn marks. I hate sanding. Try this with  the same pattern and compare. Good luck