Mantel Clock

[KarlB]

Well done Merlin.

And specifically for anyone having the magazine (as Merlin mentioned);

It is in Scroll Saw Workshop (as it was known then.  Scroll Saw Woodworking & Crafts now) Summer 2004 Issue 15 page 72.
The designer is John A. Nelson.

Karl

[Merlin]

Thanks Karl, I have missed placed my copy I've hunted everywhere for it the mind has gone me thinks.

***Merlin***

[Dakota Saw Dust]

Thanks again Merlin for the inspiration. Your right, the pattern is in SSWS Summer 2004, issue 15, page 72 by John Nelson. Also, I will be getting my clock face from NZ. Klockit and all the other suppliers don't carry anything close. One more question. Did you soak & form your roof piece? Thanks  Brian

[pddesertrat]

Thanks again Merlin for the inspiration. Your right, the pattern is in SSWS Summer 2004, issue 15, page 72 by John Nelson. Also, I will be getting my clock face from NZ. Klockit and all the other suppliers don't carry anything close. One more question. Did you soak & form your roof piece? Thanks  Brian

Can you share a link to where you are getting the clock face from? 

[Dakota Saw Dust]

Paul - Merlin posts the NZ site in his 7th reply on the 1st page of replies.  If I were more computer savvy I would have brought it up for you. Click on the under lined words following NZ.  Brian

[Merlin]

Brian: No I didn't soak this one, I cut a one piece piece.
I don't have the pattern in front of me tonite but I believe it was an 1/8 inch thick.
It was the one I had the most trouble with, When get around to doing a second one I will have a go at soaking the roof method.

Paul: clockworks

***Merlin***

[pddesertrat]

Paul: clockworks

***Merlin***

Thank you, Merlin.  I had gone back to your earlier post and found is a instructed...

[bubbaloo158]

That is nothing less than spectacular!!!  I'm sure looking forward to the day when I'll be able to do something half as good as that.
Great job.

Bobby