knobs

[Judy Hunter]

Does anyone know where I can get these small knobs?  The are 1inch high and 3/4 inch across.
Thanks in advance for any help 

[pddesertrat]

I didn't look through all these but you might find them here:

http://www.rockler.com/hardware/knobs-and-pulls/wooden-knobs-and-pulls

If I needed some I would make them on my wood lathe.  Got a wood lathe?

[jscott2]

Lee Valley http://www.leevalley.com/en/Home.aspx might have them.

Jim

[Kepy]

You might try Smithwood Products in Fort Worth.

[EIEIO]

Judy - take a look here:
http://www.craftparts.com/knobs-wooden-c-197.html

I got 100 of their KP1250 for $9.00 and have used them for drawer pulls and feet. They take the Kreg fine thread washer head pocket screws and look nice.
 

[Rapid Roger]

Both my Ace Hardware and Hobby Lobby have a small selection of wooden knobs but, I don't know if they have a match for the one you pictured.
I have made my own knobs from time to time but, I don't have a lathe so I use the scroll saw (cut them like a 3-D pattern) and end up with square knobs or the drill press and a wood rasp. Needless to say, you have to start with a larger than necessary piece of wood and work it down until it is what you want and cut to length.

Rog

[termite]

Judy check out cherry tree catalog-cherrytreetoys.com-page 109. mushroom pull knobs .

[tvman44]

Lowe's & home Depot have a few small wooden knobs.

[Dan26]

Do you know someone that owns a lathe? If I was close my I would make them for you.

[Judy Hunter]

Thanks everyone.  I have ordered the ones that were available.  I was just looking for that one in particular.
Fussy old Bag that I am

[TheMelster]

    try  www.meiselwoodhobby.com    located not too far from you!