I think you did a great job. I noticed that the sides aren't the same, why is that?
I'd like to answer but I'm not sure what you mean. The long vertical sides of the overall piece are resawn 3/4" rough sawn cedar to get two 3/8" thick blanks. Trim to 10" by 1.75", tape together, then shaped on the scroll saw. To the eye they look about identical.
If you mean the pulled-out drawer in the right photo, it is cut from a pine 2x4. Cut a blank 2"x1.5"x4.625; slice 1/4" off the bottom, cut the rest in a "U" shape, glue the 1/4" bottom back on, then glue on the 1/4" cedar drawer front. Both drawers are the same.
Or maybe it's just the way the photo came out - there were no intentional differences in any symmetrical parts.