If you still need some Inkscape instructions, you can
1. open Inkscape
2. Click on the Text Tool ("A" box along the left edge)
3. Click in the page where you want it and type your text e.g. "Line One" then ENTER then "Line Two"
4. At the top left, set your font type and size. Note if you use Scroll Beach Italic, it will not display until you set the Italics button.
5. The ENTER will put a big space between lines. You can reduce this using the 1st kerning field at the top ("A over A"). Mine starts at 8.89. Reduce it to about 1.00 or wherever looks good.
6. If you want to reduce intercharacter spacing, adjust the "AA" kerning. Mine starts at -2.65. Set it where you want it.
7. To move the text around on the page, or rotate/flip them, switch to the Select Tool (Arrow at top of left edge).
8. You can add an underlying rectangle or ellipse to define the boundaries of the blank. Change the fill at the bottom of the page, or move the rectangle/ellipse to a lower layer (Select Tool, right of the flip button) so it does not obscure the text.
