« previous next »
Pages: [1]   Go Down

Author Topic: Which finish to use???  (Read 1350 times)

Offline Keefie

  • *****
  • Hero Member
  • Posts: 4550
    • View Profile
Which finish to use???
« on: May 05, 2014, 06:56:07 am »
Hi all, I'm making a set of butterfly coasters for my daughter, what is the best finish to put on them so the hot cups won't mark them?

Keefie
Logged
It's all a case of "Mind over Matter",  The Government don't Mind, and I don't Matter.

Offline BilltheDiver

  • *****
  • Hero Member
  • Posts: 1475
    • View Profile
Re: Which finish to use???
« Reply #1 on: May 05, 2014, 08:08:48 am »
I think Polyurethane gives about the toughest finish, and waterproof.
Logged
"Measure twice, cut once, count fingers"

Offline Marcellarius

  • *****
  • Hero Member
  • Posts: 6135
  • Scrolling each day, keeps the doctor away
    • View Profile
    • Some of my work
Re: Which finish to use???
« Reply #2 on: May 05, 2014, 12:01:34 pm »
Quote from: BilltheDiver on May 05, 2014, 08:08:48 am
I think Polyurethane gives about the toughest finish, and waterproof.

think PU is the only real waterproof finish.
but might think a good clear lacquer will work as well,
only don't put them in the dishwasher ;)
Logged
Marcel

sometimes I make designer firewood....

Offline Jim Finn

  • *****
  • Hero Member
  • Posts: 507
    • View Profile
Re: Which finish to use???
« Reply #3 on: May 05, 2014, 10:20:01 pm »
I would avoid lacquer and use Varithane or an epoxy.
Logged
20"Hegner Polymax-3 (2008)
25"Hegner Multimax-3 (1986)

No PHD, just a  DD 214
Pages: [1]   Go Up
« previous next »
 

SMF

Teknoromi

SMF Links

  1. XHTML
  2. RSS
  3. WAP2
  4. Theme by snrj