Seems a little slow on the Forum just now, so here's a new design that was easy to make and turned out pretty good.
This is a wooden spoon that was cut like a scroll saw bowl. It is cut from 1" Birch hardwood from a 1"x2"x10" blank. The inside of the bowl is cut out, glued to the back of the bowl area, then trimmed down to 1/8" thick and sanded smooth.
The attached PDF shows the instructions and the basic shape, but these spoons are usually carved with a hatchet and knife and have more curvy lines and decorative touches, especially in the handle. So start with the basic pattern, but experiment with curves, shapes, decorations, etc.
The spoon shown has a bowl size of 2 tablespoons.
