name plate

[skip]

would like to see if i could get a pattern   a name plate       ROBBIES PLACE   would like the first letter R to be about 2 inces high   going up to the s about 3 inches than back down to 2 inches for the e on place   how i made that sound right   thank you very much     skip

[Proxprof]

Hello Skip,

I gave it a try.
Is this what you mean?
You have to print it in the right size.
I'm new to this so give me some respons.

Richard

[skip]

how about a space  between robbies and place  other than that agood job  thank you

[Russ C]

Name plate? Do you mean as in, sits on a desk or hangs on a wall?

[skip]

one for the desk would be fine     thank you

[Russ C]

How about this.

[skip]

good one russ  thank you very much

[frankorona]

Very nice patterns, thank you for your help

[kingcole]

go to steve d goods blog  he has several free programs that you need to help you make your own patterns

[EIEIO]

Just to make sure - You might want to check the syntax before cutting.

If the name is "Robby" then the sign should probably read "Robby's Place" (also note the apostrophe).

If his (or her) name is "Robbie" then it should look like "Robbie's Place" (adding the apostrophe).

If it's already a trademark w/o the apostrophe then leave it off.

[skip]

he liked the one russ drew  so we cut that one     i glad i didnt have to choose  they were are  good   i put a picture of it on here   i think in the brag section    THANK YOU ALL    SKIP