« previous next »
Pages: 1 [2]   Go Down

Author Topic: Fast or Slow Cut  (Read 3620 times)

Offline BilltheDiver

  • *****
  • Hero Member
  • Posts: 1475
    • View Profile
Re: Fast or Slow Cut
« Reply #15 on: June 30, 2010, 03:54:25 pm »
I tried a router speed control on a drill press (the variable speed circuit board has crashed)  I could control the speed, however when the speed decreased, so did the power.  I'm not sure how big a factor this might play with a scroll saw.
Logged
"Measure twice, cut once, count fingers"

Offline tas2181

  • *
  • Newbie
  • Posts: 32
    • View Profile
Re: Fast or Slow Cut
« Reply #16 on: June 30, 2010, 06:56:25 pm »
Be careful putting a variable control on your saw.
Generally, if the saw motor uses brushes, you can use a control. if it does not have brushes, a rheostat type speed control could ruin the motor.
Logged

Rightarm

  • Guest
Re: Fast or Slow Cut
« Reply #17 on: July 01, 2010, 06:34:51 pm »
    Thanks for the info Tom. I'll have to check the specs to see if it has brushes or no. Dave
Logged
Pages: 1 [2]   Go Up
« previous next »
 

SMF

Teknoromi

SMF Links

  1. XHTML
  2. RSS
  3. WAP2
  4. Theme by snrj