Author Topic: Fixing up a Reliant 26" Scroll Saw  (Read 3834 times)

FreqManMHZ

  • Guest
Fixing up a Reliant 26" Scroll Saw
« on: May 19, 2011, 09:49:31 pm »
I?m new to this forum, and I would appreciate some advice on a used single speed Reliant 26" scroll saw in very good condition.  The plate on the saw calls it a Model DD26, but the owner?s manual calls it an "MS-26 Scroll Saw" with no mention of Reliant.  After some basic clean-up and adjustment it seems to be working well.  I reduced vibration by placing two bags of cement on a shelf in the base of the stand that came with the saw.   In order to speed blade changes, I modified the plate insert to allow the lower blade holder to pass through easily.  The existing blade holder system seems cumbersome with these usual box shaped chuck guards.   Does anybody have any experience with aftermarket blade holders for this generic saw or a similar model?   Also, since it?s a single speed saw, is it possible to use an in-line power variable speed controller without damaging the motor?  Thanks!

Offline dgman

  • *****
  • Hero Member
  • Posts: 6916
    • View Profile
Re: Fixing up a Reliant 26" Scroll Saw
« Reply #1 on: May 19, 2011, 10:22:38 pm »
welcome to the forum. I don't know anything about your scroll saw other than Reliant was a house brand of several now defunct mail order woodworking catalog's and store's. Most Reliant tools where imported from China or Taiwan. Other importers probably sold the same machine under different brand names. If you can post a picture of your scroll saw, maybe we can help.
As far as installing a speed control, Don't! You will most likely burn out the motor! In which case you will have to purchase a  more user friendly scroll saw! ;D
« Last Edit: May 19, 2011, 10:26:01 pm by dgman »
Dan In Southern California

 

SMF

Teknoromi