« previous next »
Pages: [1]   Go Down

Author Topic: promble  (Read 724 times)

david45

  • Guest
promble
« on: January 28, 2011, 07:48:00 am »
i am using a.2 blade an it wont stay in my srcollsaw its delta any help
Logged

Offline julief

  • *****
  • Hero Member
  • Posts: 3137
    • View Profile
Re: promble
« Reply #1 on: January 28, 2011, 08:01:50 am »
What might be the problem is, if you are used to using a bigger blade, you could have a wear pattern in you blade holders.  It may be just enough to keep from getting a grip on the tinier blade.  You might rough up the ends of your blade holders just a bit.
Logged

Offline Russ C

  • *****
  • Hero Member
  • Global Moderator
  • Posts: 8458
  • Central Florida - USA
    • View Profile
Re: promble
« Reply #2 on: January 28, 2011, 08:30:08 am »
Try cleaning the ends of the blade too. They can have a small amount of oil from manufacturing. You can also lightly sand the ends of the blade.  8)
Logged
russ@simplywoodencreations.com

Keep The Blade On The Line.

tux_linux

  • Guest
Re: promble
« Reply #3 on: January 28, 2011, 09:32:58 am »
The problem seems to be confusing - he even lost his grammar  :o

Clean the clamps too. There might be too much dust in there - especially if it's the bottom clamp.

regards
Torsten
Logged

pauley555

  • Guest
Re: promble
« Reply #4 on: January 28, 2011, 01:27:03 pm »
not sure but on my scroll saw i have different size blade holders for different  blades,and had same problem until i got the right sized holder,hope this may be of help,regards paul
« Last Edit: January 28, 2011, 02:04:34 pm by pauley555 »
Logged
Pages: [1]   Go Up
« previous next »
 

SMF

Teknoromi

SMF Links

  1. XHTML
  2. RSS
  3. WAP2
  4. Theme by snrj