« previous next »
Pages: [1]   Go Down

Author Topic: Delta SS350  (Read 1385 times)

ups34

  • Guest
Delta SS350
« on: December 19, 2010, 06:40:06 am »
Anyone using a Delta SS350 ? Looking for some information on that saw. I need the height of the saw from the bottom to the table. I have one in Fl. and building a stand for it here in Maryland to take there.
Logged

KYCustomScroller

  • Guest
Re: Delta SS350
« Reply #1 on: December 19, 2010, 08:22:53 am »
i use it i just bought a new one on stand and ever stuff.....................?????
Logged

ups34

  • Guest
Re: Delta SS350
« Reply #2 on: December 19, 2010, 01:30:41 pm »
Ky.
Can you help me with the measurement. I don't have it here.
Logged

ups34

  • Guest
Re: Delta SS350
« Reply #3 on: December 19, 2010, 01:36:13 pm »
KyCustom
If you are using a SS350 you must have bought it used.
Logged

KYCustomScroller

  • Guest
Re: Delta SS350
« Reply #4 on: December 19, 2010, 06:38:21 pm »
yea brb i'll go get the measurements, Ok from my concrete shop floor to the bottom of the base of the saw is 30 3/8" i hope this helps you.
« Last Edit: December 19, 2010, 06:41:36 pm by KYCustomScroller »
Logged

KYCustomScroller

  • Guest
Re: Delta SS350
« Reply #5 on: December 19, 2010, 06:42:29 pm »
Quote from: ups34 on December 19, 2010, 01:36:13 pm
KyCustom
If you are using a SS350 you must have bought it used.
yea it was used very little it was in new condition not a scratch on it
Logged

ups34

  • Guest
Re: Delta SS350
« Reply #6 on: December 19, 2010, 08:23:47 pm »
KYCustom
Thanks but I was looking for how tall the saw is from the bottom of the saw to the table. It should be something like 8 inch.
Thanks for your help
Logged
Pages: [1]   Go Up
« previous next »
 

SMF

Teknoromi

SMF Links

  1. XHTML
  2. RSS
  3. WAP2
  4. Theme by snrj