Desk Stand

[woodyd]

Looking for suggestions how to make this into a desk top stand with better details, rather than just a silhouette. Thanks in advance.

[spirithorse]

Hi, Woodyd,
You could cut out the picture you show here, glue it to the wood stock
with spray adhesive, and then cut it out. Just draw a rectangular base
on the wood stock before you cut it or cut out a separate base and
screw the picture onto the base.
God Bless! Spirithorse

[woodyd]

Thanks Spirit, that's what I do when making magnets. However, with this project, wanted it to be a wood sculpture. This is just a rough draft, but think I can make something like this to work. Thin vein lines to show detail.

[woodyd]

Needs to be cleaned up but, I think something like this will work. Leaving out the facial details.

[spirithorse]

Nice work! Doesn't look like you needed any help.
Just make sure to leave plenty of bridges so it doesn't
become too fragile.
God Bless! Spirithorse

[woodyd]

Here's the cut.

[dunk]

That turned out fine and you did it without help after all.