Great save. Just my 2 cents. I would have done a round over on the backer board or an ogee cut with my router to dress it up a little but yours turned out nice as well.
I'm always amazed that you don't use a sacrificial piece under your work when you drill and spray lacquer directly on your work bench. In time you will begin to notice quite a bit of build up. Do you sand it down from time to time? I always have a protective layer on top of my bench.
Thank you all, I actually didn't drill through that bench, I moved it and drilled onto another board off camera. The spray doesn't affect me much, if I spray something that is larger than this, I usually put it on a cardboard piece and spray on the floor. Just a little thing like this doesn't need special attention
If I had more room in my shop, I would make a designated spray booth.
