Author Topic: stack cutting?  (Read 1369 times)

Offline arkiewood

  • **
  • Jr. Member
  • Posts: 91
    • View Profile
stack cutting?
« on: December 17, 2012, 09:16:32 pm »
Is 4 layers of 1/4 in Birch too much to cut at one time?
Let's make some saw dust!

Offline dgman

  • *****
  • Hero Member
  • Posts: 6916
    • View Profile
Re: stack cutting?
« Reply #1 on: December 17, 2012, 09:47:36 pm »
The thing to remember is there are multiple layers of glue you are cutting through. All that glue is tough on blades. For 1/4" BB I will stack two layers.

Dan In Southern California

Offline GrayBeard

  • *****
  • Hero Member
  • Posts: 7088
  • My DW 788 sends you HUGZZZZ from Missouri, USA!
    • View Profile
Re: stack cutting?
« Reply #2 on: December 17, 2012, 10:51:07 pm »
IF you don't mind giving FD Mike more business then go for it. That Mountain Lion I just finished was 2 - 1/8 and 2 - 1/4
plywood and cut just fine using 2/0 FD New Spirals....
However, I went through over 3 doz. blades on that one project. The glue sure heats them up and they wear out quick.

I would not hesitate to do 1/2 of BB with any of my blades.

~~~GB~~~
I never really wanted to grow up....All I wanted was to be able to reach the cookie jar...and play with my DW 788

Offline arkiewood

  • **
  • Jr. Member
  • Posts: 91
    • View Profile
Re: stack cutting?
« Reply #3 on: December 18, 2012, 09:56:49 am »
Thanks for the replies I am using FD-UR #1 and I do go thru several blades. I just ordered 2 doz. first time and then ordered 3 more lately.
Let's make some saw dust!

Offline Danny

  • *****
  • Hero Member
  • Posts: 1671
    • View Profile
Re: stack cutting?
« Reply #4 on: December 18, 2012, 12:09:48 pm »
2 layers 1/4"....  BB....  Just finished cutting using a 1/8" on the Bottom.  Used
the FD-UR #1 for the complete project.  Yes....I did go thru a few blades.  The
bottom layer came out as good and clean as the other 2.  Yea!

Wrong area, but want to post a picture.  Chris Messer has started this project.
If you want to be involved go to FB and he has all the info.  Anyway....  Danny  :+}
Danny  :+}

ChuckD

  • Guest
Re: stack cutting?
« Reply #5 on: December 18, 2012, 04:38:05 pm »
I very seldom go more thatn a half inch of plywood for stacking.  So that is 2 1/4 and 4 1/8.  Good Luck  :):)

 

SMF

Teknoromi