Author Topic: Drilling Holes In The Middle  (Read 4080 times)

stipes

  • Guest
Re: Drilling Holes In The Middle
« Reply #15 on: March 19, 2012, 04:04:53 pm »
Gabby, that is great for pieces with large cut-outs, but how about fret work with tiny, lacy cut-outs. You wouldn't be able to see where to center the hole in the aid. Maybe if the scrap wood was cut in two, thru the drill hole. It could be lined up with the small place to be cut and the drill bit held against it. Haven't tried that tho.
We all do different types of scrolling.
Pat B
  Hi Pat. you can use a piece of Lexan then instead of metal. I like lexan instead of plexiglass cause plexi will shatter and chip easy...

Offline mainberg

  • ***
  • Full Member
  • Posts: 121
  • Better than drivers' license pix
    • View Profile
    • Photo Bucket
Re: Drilling Holes In The Middle
« Reply #16 on: March 19, 2012, 11:40:58 pm »
Yes, I like the idea of the Lexan. Hmm, must find out where to get some.
Pat B

Offline Gabby

  • *****
  • Hero Member
  • Posts: 3069
  • Yer durn tootin'!
    • View Profile
Re: Drilling Holes In The Middle
« Reply #17 on: March 20, 2012, 02:47:01 am »
Play with it a bit Pat, I'm not going to hand it all to you on a silver platter. It'll work.
Use your noggin,
Gabby
MOLON LABE.
TRUST IN GOD!
 DON'T BELIEVE ALL YOU HEAR & DON'T SAY ALL THAT YOU THINK !

 

SMF

Teknoromi