Author Topic: rough cut on 1" maple (Read 1132 times)

tux_linux · « **on:** July 10, 2011, 04:12:17 pm »

Hey!

I made some cuts this evening on some mighty fine 1" maple.

Turns out the cuts are pretty rough. I used a FD-SR5 which I considered to be just big enough. The cutting itself was fine, but the result is not really pretty.

Is it the wood? Did I miss on the blade selection?

dgman · « **Reply #1 on:** July 10, 2011, 04:23:40 pm »

Hey Torsten, I would think your blade selection was good. What speed were you running you blade? Did you use any packing tape?

dunk · « **Reply #2 on:** July 10, 2011, 07:04:32 pm »

Maple seems to have a tendency to tear for me as well. I see the same fibers when cutting it.

KarlB · « **Reply #3 on:** July 10, 2011, 10:25:20 pm »

I just cut even thinner maple and I see the same thing. To me your cuts look good because I don't see any burn marks!

Good job.

Karl

tux_linux · « **Reply #4 on:** July 11, 2011, 04:10:03 am »

OK, so I'll take that as a lesson learned.
The maple wood is quite soft, this might be the result. I'll try that cutting on some beech wood I have here (3/4").

Dan, I have my new Hegner running, which has no speed control. Works fine so far.

chief · « **Reply #5 on:** July 11, 2011, 01:42:09 pm »

I have tried many different blades on different thickness maple and I always end up with the fuzz on the back. The fier the blade the less amount of fuzz though.

News: Had a couple issues with the forum today. 1/19/2017. I believe I have them corrected now. Let me know if you have any trouble. Thanks.

Author Topic: rough cut on 1" maple (Read 1132 times)

tux_linux

rough cut on 1" maple

dgman

Re: rough cut on 1" maple

dunk

Re: rough cut on 1" maple

KarlB

Re: rough cut on 1" maple

tux_linux

Re: rough cut on 1" maple

chief

Re: rough cut on 1" maple

SMF

SMF Links