Adjustble Rear Table Bracket DW788

[MOONIE]

A while back a post described an adjustalbe rear table bracket to cure the front/back blade movement on the DW788. It has 1/4'' slotted holes on either side so the table can be adjusted up and down.   Well, I made one from walnut and I'm delighted to report it worked perfectly!  This is the only fourum I read but I can't find the original post to refer you to.

[jscott2]

Moonie, I made one for my Delta 40-690 (788 clone) like this - easy to do.  It permits adjusting the tilt of the table.

I found it helped but didn't completely remove the forwards and backwards motion of hte blade - your mileage may vary.   

Hope this helps.
Jim

[MOONIE]

I put two pieces of card stock  cardboard  under the homemade gizmo and got lucky.  It made a world of difference.  I figured it was going to trial and error as how much material to add.  Some time ago there was a post on this forum, for the gizmo cut from walnut.  That's what I used, but can't find it. I just wasn't comfortable cutting slots.