Pattern for the Thumb Screws on the DeWalt 788

[ToverT]

Steve,

Do you or anyone have a template to make the overlays for the tumb screws on the DeWalt 788?

Thanks,
ToverT

[dgman]

Hey ToverT, Here is one for the DeWALT: http://www.stevedgood.com/dewaltupgrade.pdf
And this one is for the Excalibur, but should fit the DeWALT: http://www.stevedgood.com/ex21knob.pdf
Welcome to the forum! Please go to the introduction page and introduce yourself so we can welcome you properly!

[ToverT]

Thanks Dgman.  Ha, and I looked in the pattern tab on his site and didn't see that!  These darn eyes of mine!  Thanks again

ToverT
Rustic Wood Artistry

[Barry]

Be careful ToverT, these can put a lot of torque on your blade holders.  I stripped my top one out after a short time.  I ordered two replacements and have gone back to the original thumb screws.  You might be alright, just my experience.  Good luck.

Barry