Messages

1

The Coffee Shop / Re: Belt Sander question

« on: July 28, 2016, 07:25:42 pm »

Dennis

 Your on the right track I went out and removed the belt cover and there was another idler under the table so I re routed the belt and it would work like that. I just need to figure out how to keep the top idler from swinging.

Thanks for all the replies and help.

2

The Coffee Shop / Re: Belt Sander question

« on: July 27, 2016, 08:22:02 pm »

Ok its a wholesale tool sander model 3230-0010 I found a manual for a 3230-0020 and it didn't say anything about adjusting the belt or pulley .     

I didn't see any type of spring for the arm or pulley either so I'm assuming that it just keeps the belt off the upright guide for the belt .

3

The Coffee Shop / Re: Belt Sander question

« on: July 27, 2016, 06:55:27 pm »

I have the cover and the screws that screw into it   unless there's a spring missing I don't see anything missing     the belt travels down so I don't see how it could tension     

I checked the grizzly model its different.      I will check the make later and post it.   

4

The Coffee Shop / Belt Sander question

« on: July 26, 2016, 08:47:55 pm »

I picked up a belt and disc sander combo.   It uses a 1"x42" belt.   I installed the belt, but not sure what this pulley is supposed to do  I tried putting the cover on and sliding the pulley towards the belt and tighten it but it moves with the cover and I don't see what it's supposed to do.

Anyone ever saw onelike this?

5

Pattern Requests. / Looking for a sandrail pattern ?

« on: November 21, 2015, 09:33:42 am »

Hello I'm looking for a simple sand rail pattern.  I looked for a good photo but nothing I thought be useable.   

Does anybody have a pattern they would like to share?