Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Toneman

Pages: [1] 2 3 ... 74
1
Introduce Yourself. / Re: Hi Everyone
« on: December 03, 2021, 10:39:04 am »
Welcome! I am Tony,aka Toneman from Paris, Texas.

2
Introduce Yourself. / Re: New Member
« on: December 03, 2021, 10:37:25 am »
Welcome! I am Tony, aka Toneman from Paris, Texas.

3
General Scroll Saw Talk / Re: Theatre comedy and tragedy masks pattern?
« on: August 19, 2021, 04:24:06 pm »
Just read your thread, sorry for being so late. You may try Sue Mey Scrollsaw artist website. She has made a few custom patterns for me. Want hurt to look at her page and contact her. Hope this helps.

4
General Scroll Saw Talk / Re: Neck pain
« on: March 21, 2021, 11:51:10 am »
I found my neck and shoulders hurting when I first started scrolling. Besides adjusting my chair and saw stand and good lighting, I discovered I was tensing up so I learned to take a deep breath and drop my shoulders. I realized my shoulders were up and not down.

5
Introduce Yourself. / Re: Hey Everyone!
« on: March 21, 2021, 11:46:00 am »
Glad to have you aboard! I am Tony,aka, Toneman from Paris, Texas.

6
Introduce Yourself. / Re: new to the forum
« on: March 21, 2021, 11:44:39 am »
Welcome! I am Tony from Paris, Texas. Glad to have you aboard!

7
Introduce Yourself. / Re: Hi new here
« on: December 17, 2020, 04:47:27 pm »
Welcome! I am Tony,akaToneman from Paris, Texas.

8
Introduce Yourself. / Re: New member in kansas
« on: December 17, 2020, 04:46:38 pm »
Welcome to the forum! I am Tony,aka Toneman from Paris, Texas.

9
Introduce Yourself. / Re: New Member Introduction - Roman Miller
« on: September 07, 2020, 06:53:19 pm »
Welcome! I am Tony,aka,Toneman from Paris, Texas.

10
Introduce Yourself. / Re: GREAT TO BE IN THE CLUB
« on: September 07, 2020, 06:52:07 pm »
Welcome! I am Tony,aka, Toneman from Paris, Texas.

11
Introduce Yourself. / Re: Newbie from Kentucky
« on: May 26, 2020, 09:10:50 am »
Welcome! I am Tony,aka,Toneman from Paris, Texas.

12
General Scroll Saw Talk / Re: stack cutting
« on: May 11, 2020, 05:43:49 pm »
I use blue painter's tape and only attach the tape about every other inch around the edges of the stacked wood. I use pieces just long enough to make sure the wood is secure (about 1/4" on top and bottom. ie, if stacked wood is 1" I would cut my tape pieces 1 1/2". Make sure wood is clean from dust so tape will stick. I use 3M 77 adhesive to secure pattern and when finished I spray a light coat of mineral spirits to remove pattern. Hope this helps. Also, cutting 1"thick requires a slow slow cut or else blade will bend or get too hot and will break.

13
Introduce Yourself. / Re: New guy from Arizona
« on: May 11, 2020, 05:31:49 pm »
Very nice! Welcome to the forum! I am Tony,aka,Toneman from Paris, Texas.

14
Introduce Yourself. / Re: New from Virginia Beach, VA
« on: April 22, 2020, 11:46:59 am »
Welcome! I am Tony,aka,Toneman from Paris, Texas.

15
Introduce Yourself. / Re: New member from Westport, MA
« on: April 22, 2020, 11:46:09 am »
Welcome! I am Tony,aka,Toneman from Paris, Texas.

Pages: [1] 2 3 ... 74

SMF

Teknoromi