Messages

1

Toy Makers / where is the pattern?

« on: May 27, 2020, 07:23:29 pm »

sorry new here but i followed some thread for small cars and trucks and it shows a pattern attached but when i key on it there is no pattern is that because the listing is too old or is there something wrong with my comp? I got a couple to work but most didn't bring the pattern up

2

Ask Steve a question. / Re: restoring tension to a Delta, 16 inch 2 speed (model 40-560?)

« on: January 31, 2020, 03:28:31 pm »

i have had a 40-560 my whole life and never experienced the problem you describe there is a bolt on the top arm that i replaced years ago that adjusts tension and you might have to go to the hardware store and find a similar bolt to retention the arm, i had to stop using mine because of the wiring went bad but i still have the saw. I think that bolt is the problem you are experiencing but of course cant say for sure unless i see it

3

Ask Steve a question. / thank you

« on: January 31, 2020, 03:25:13 pm »

i have been scrolling a long time and when i did most of it it was 30 years ago and there wasn't many patterns and you couldn't find other people interested today it has seemingly taken off its better machines and patterns and folks involved and i have to hand it to you in making all the patterns you do available on your site and the forum and the you tube videos you put out. all i can say is thanks i appreciate all your efforts for making this art form better and stronger and of course to help people out

4

Pattern Requests. / a bell in the round

« on: January 31, 2020, 03:20:48 pm »

looking for a bell pattern as we say in carving in the round what i am envisioning is cutting out circles and then assembling them to make a small bell should be easy enough  but i don't know how to make patterns and i would pay a reasonable amount for the patterns thanks

5

Introduce Yourself. / new guy

« on: January 31, 2020, 03:18:46 pm »

new ti the group been scrolling for 39 years I am basically starting over with a new pegas saw after taking a few years off to carve. it will be good to be with like minded folks thanks for having me