Messages

1

General Scroll Saw Talk / Re: Newbie Scroller Questions

« on: February 15, 2017, 07:50:01 pm »

Another place to check is cabinet and flooring installer companies.  When they install those a lot of times they have to trim them and most of the time... at least here in the States they get tossed.  Just an idea.


DW

Thanks DW I'll make some enquiries.

2

General Scroll Saw Talk / Re: Newbie Scroller Questions

« on: February 15, 2017, 07:11:09 pm »

Thanks for the helpful tips and suggestions. We don't have Home Depot in Australia, however we do have Bunnings Warehouse which I beleive is similar so I'll try there for the lumber off cuts.

Thanks again,

Silvertayl 57

3

General Scroll Saw Talk / Newbie Scroller Questions

« on: February 15, 2017, 12:28:57 am »

Hi,

 I am a newbie to scroll sawing and I have a few questions on getting started.

 I bought an entry level scroll saw: a Ryobi 125W 45mm some 3 and 7mm plywood an some pin-less blades of varying types and sizes and I would like to begin scrolling. My aim is to make jigsaw puzzles, key-rings, word and wall art, however I need to practice before I attempt anything for real.

 My questions are is the plywood okay for this and what type and size blades are best for practicing?

 I apologize in advance if these questions have been asked and answered a thousand times before.

 Thanks for reading.

 Silvertayl 57