Messages

1

General Scroll Saw Talk / Re: tape residue

« on: January 20, 2022, 12:20:47 pm »

Nicole, If you lightly sand your wood before you apply the shelf liner, and be sure to wipe the dust off after sanding, it will help a LOT with the lifting you spoke of. I use 220 grit paper to do the sanding.

2

General Scroll Saw Talk / Re: What Glue?

« on: December 05, 2019, 11:28:59 am »

Titebond III or Epoxy will do well

3

General Scroll Saw Talk / Re: HF

« on: March 30, 2019, 01:53:21 pm »

Get a handy box from your big box store, install a regular light switch with a cover and mount it to your table, you will probably never have to replace it. Just a suggestion.

4

General Scroll Saw Talk / Re: Spoon rack

« on: March 07, 2019, 11:30:23 am »

If you want smaller rings just reduce the size on your printer page like make it 75% in place of 100% and see what you get

5

General Scroll Saw Talk / Re: Whats Happened ?

« on: February 23, 2018, 05:49:47 pm »

I notice that a LOT of people just post the same comments just worded a little differently. I realize that some want to increase their post count and have no real information to add andI gears that's O.K. I for one get tired of reading the same thing over and over, Kind of like watching the news.
 Just my $.02

6

General Scroll Saw Talk / Re: Hegner collected today

« on: February 18, 2018, 11:51:23 am »

Congratulations on your new saw, you are all set now for a lot of enjoyment, Have fun.

7

General Scroll Saw Talk / Re: Scroll Saw School not working

« on: January 28, 2018, 08:08:43 pm »

The tool bar at the top states that the scroll saw school is not working

8

General Scroll Saw Talk / Re: Child safe woods

« on: October 01, 2017, 11:32:11 am »

I would avoid any tropical hardwood with the exception of Mahogany, My personal choice would domestic hardwood like Cherry, or Maple, or Walnut, something that is close grained and not prone to splintering

9

Introduce Yourself. / Re: Just another retiree in Illinois

« on: February 21, 2017, 09:13:05 pm »

Welcome Dave.
. I'm fairly new here too

10

General Scroll Saw Talk / Re: Blade feeding

« on: February 06, 2017, 11:06:07 am »

Bottom Feed here
 

11

General Scroll Saw Talk / Re: Steve's Video - Wixey Digital Angle Gauge - for Jet and Excalibur Saws

« on: January 29, 2017, 02:54:16 pm »

I'm usually setting 3,4, up to 10 degrees, so the gage doesn't slide off the table.  However, if you were to set up for a 45 degree it would slide off. Cheers Brian

 Brian, the angle gauges have rare earth magnets in the base and will not slip off the table.

12

Toy Makers / Re: More toys

« on: January 23, 2017, 09:42:15 pm »

http://www.greenvillewoodworkers.com/subpages/toyplans.htm

13

Introduce Yourself. / Hello from Northern Ky

« on: January 19, 2017, 08:44:01 pm »

 Finally got registered today, I'm fairly new to scrolling, I have a DeWalt 788 saw. I have been a woodworker for 50+ years and always looking for new tips and tricks. Looking forward to seeing everyones work