52
« on: June 29, 2014, 05:58:21 pm »
Delta 16 inch varible speed saw.
Today I was lubing the saw - Removed upper and lower pivot pins
per the manual. Both came out normallyand the bottom one went
back in fine but the upper one will not tighten. I have run a tap into
the hole in the casting (8mm/125) still no luck. (yes that is the size)
A screw of that size tighens just fine in the casting. Pivot pin threads
look OK and a nut tightens on it fine.
Any thoughts ?
Is it time to look for a new saw? AL