436
Tutorials, Techniques and Tips / Stack Cutting Question
« on: June 20, 2012, 06:12:04 pm »
I'm starting a project stack cutting 3 layers totaling about 1/2" thick. Each resulting 1/8" plus thick plaque will be glued to a 1/2 or 3/4" backer of dark wood.
The design will be cut away from the plaque. I am having a problem with the letter "P" - I want to cut out the "hole" in the loop of the "P" and then glue it in the correct position on the dark backer.
I've done this before but only on a single layer cut. When I started cutting the "hole", I realized that with 3 layers being cut, it would be very difficult to keep the layers together. There would likely be pieces flying everywhere.
I don't want to have "connections" to hold the "hole" in place, I want it to be a real island.
I hope I have clearly explained the problem. I suppose one option would be to separate the layers but I would prefer to cut them all in one cut.
Has anyone has any idea(s) so that I can make the cuts?
Thanks for your help.
Jim
The design will be cut away from the plaque. I am having a problem with the letter "P" - I want to cut out the "hole" in the loop of the "P" and then glue it in the correct position on the dark backer.
I've done this before but only on a single layer cut. When I started cutting the "hole", I realized that with 3 layers being cut, it would be very difficult to keep the layers together. There would likely be pieces flying everywhere.
I don't want to have "connections" to hold the "hole" in place, I want it to be a real island.
I hope I have clearly explained the problem. I suppose one option would be to separate the layers but I would prefer to cut them all in one cut.
Has anyone has any idea(s) so that I can make the cuts?
Thanks for your help.
Jim