213
« on: July 19, 2016, 09:01:46 pm »
I have been at the scroll saw for several years now so am not a newbie. I use a DeWalt 788. Today I ran into a problem that has me very FRUSTRATED!! I am a bottom feeder. When I try to put the blade into the top clamp It acts like it is being cut off. It snaps as soon as I apply any tension. I have gone through several dozen blade trying to figure out what is wrong. I have tried to use very light pressure, just enough to hold the blade
Here is what else I have tried so far:
New thumb screw
New set screw
New Blade Clamp
Tried different blades: FD 0/3 Spiral, Galaxy 0/2 spiral (I use spirals for everything)
PLEASE, At this point I am willing to try anything.