106
Brag Forum / Cutting Board
« on: November 26, 2013, 08:51:37 pm »
I know this was not done by scroll saw. It was however done completely without the use of a table saw as I do not own one. I used a 9" bandsaw, hand plane, a thicknesser and router. This cutting board was a commission piece for a lady. She wanted an 18 x 24 inch cutting board, so that is what I made her. The woods used are Maple and Sapel. I sanded it to 400 grit and then treated it to 4 coats of mineral oil ( butcher block oil ) and then a bees wax and butcher block oil mix for the final coating. The board ended up just a 32nd under 1 inch thick.
![](http://s24.postimg.org/tpg89somp/cuttingboard.jpg)
DW
![](http://s24.postimg.org/tpg89somp/cuttingboard.jpg)
DW