Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Marcellarius on March 19, 2012, 04:11:11 am

Title: Lion-Lamb
Post by: Marcellarius on March 19, 2012, 04:11:11 am

With easter coming I would make something special so I made this pattern and project.
due to the fact I'm not a good pattern maker, the pattern had a lot of small curves pieces.
way to small even for the UR #2/0 or the Penguin #1 (on the computer screen pieces smaller the 1/64 can look quit big 8))
but along the way tried to follow the lines as best as could and every here and there a small part was skipped.
that's the beauty of scrolling after you take away the pattern, nobody can see that you skipped some  ::)  

stacked 3 pieces of A4 (11.7x8.3) 1/8 (3mm) thick baltich birch plywood.
didn't finished it yet, can't make up my mind if I would use lacker or oil on this project

Title: Re: Lion-Lamb
Post by: Keefie on March 19, 2012, 05:15:32 am

you would never guess you had skipped any cuts - looks beautiful. thanks for sharing.

Title: Re: Lion-Lamb
Post by: Marshall on March 19, 2012, 05:54:52 am

Marcel , looks great................

Title: Re: Lion-Lamb
Post by: Russ C on March 19, 2012, 08:44:27 am

Looks fantastic, nice job. Thanks for sharing.  :)

Title: Re: Lion-Lamb
Post by: SheGold on March 19, 2012, 09:34:50 am

Marcel that is absolutely beautiful... You'd never guess there were places not cut... Lovely... Sheila

Title: Re: Lion-Lamb
Post by: Tomsunnu on March 19, 2012, 10:28:47 am

Very nice pattern and the cutting also looks  great!

Title: Re: Lion-Lamb
Post by: frankorona on March 19, 2012, 11:18:57 am

Awesome job, very well done

Title: Re: Lion-Lamb
Post by: Al W on March 19, 2012, 11:54:09 am

Well done.  Thanks for sharing.

Title: Re: Lion-Lamb
Post by: wombatie on March 21, 2012, 01:34:21 am

Fantastic.

Marg

Title: Re: Lion-Lamb
Post by: newfie on March 21, 2012, 09:13:15 am

thats nice thanks for sharing

Title: Re: Lion-Lamb
Post by: Danny on March 21, 2012, 10:02:18 am

Wow!  Your design and cutting came out Beautifully.  As everything you do.  Well done....  Friends....  Danny  :+}

Title: Re: Lion-Lamb
Post by: Dawie on March 21, 2012, 01:46:16 pm

I like it a lot. You did a great job. Thanks for sharing.
David

Title: Re: Lion-Lamb
Post by: chelcass on March 21, 2012, 03:41:30 pm

Beautiful cut, thanks for sharing

Title: Re: Lion-Lamb
Post by: Marcellarius on March 24, 2012, 12:27:00 pm

thanks everyone for your kind words.

Title: Re: Lion-Lamb
Post by: Intarsia92 on March 24, 2012, 02:24:12 pm

Very very nice, Great pattern.

Title: Re: Lion-Lamb
Post by: GrayBeard on March 24, 2012, 02:29:56 pm

That is one fine piece of Scrolling Artistry!

You certainly do NOT have to apologize for anything with that piece!

Beautiful!

~~~GB~~~