Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: stett14 on January 28, 2012, 01:34:24 pm

Title: Sanding scroll saw project made from computer CD
Post by: stett14 on January 28, 2012, 01:34:24 pm

 Steve:I was reading about a scroll sawer who made some small characters and lettering using computer CD.  I tried it and it cut great.  However what do I use to sand and cleanup the plastic fuzzies without hurting my project?

Thanks for all you hard work and effort on this scroll saw site.  I enjoy every minute of reading items from this site.

Stett 14

Title: Re: Sanding scroll saw project made from computer CD
Post by: GrayBeard on January 28, 2012, 02:46:22 pm

I use a set of small "needle" files on my portraits and that should also work to remove the plastic fuzzies for you.

~~~GB~~~