Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: ex-28 on January 08, 2012, 11:14:13 pm

Title: Req: push block pattern
Post by: ex-28 on January 08, 2012, 11:14:13 pm

just wondering if anyone has any pattern around to make a push stick or block for use on table saw  ? ,

greatlly appreciated  , thanks

MIke

Title: Re: Req: push block pattern
Post by: wsmith0896 on January 12, 2012, 11:24:12 am

This is what I use all the time on my tablesaw.

Title: Re: Req: push block pattern
Post by: Fab4 on January 12, 2012, 04:57:04 pm

Hi Wade:
Thanks for the reply
I kept a copy
Fab4

Title: Re: Req: push block pattern
Post by: Russ C on January 12, 2012, 05:40:55 pm

Sorry Wade, but that .doc contains a pattern made by someone else and cannot be posted here. 

Title: Re: Req: push block pattern
Post by: ex-28 on January 12, 2012, 10:27:03 pm

url's are ok i belive if your avble to post , thanks again .

Title: Re: Req: push block pattern
Post by: Raptor66 on January 13, 2012, 08:06:17 am

There is a good one in the latest Wood magazine.

Title: Re: Req: push block pattern
Post by: Russ C on January 13, 2012, 08:29:40 am

Here is one you can use. The smaller you can make the hole for the handle the better. It will make it stronger. Stay safe.  :)

Title: Re: Req: push block pattern
Post by: Jim Finn on January 13, 2012, 10:06:17 pm

Here are some I make. I make about 10 at a time from scrap because they are "consumable"

Title: Re: Req: push block pattern
Post by: ex-28 on January 13, 2012, 10:08:21 pm

thanks for all the ideas all , really appreciate !