Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Dawie on November 14, 2011, 05:45:22 pm

Title: Steve's mininativity
Post by: Dawie on November 14, 2011, 05:45:22 pm

 I could not help myself when I saw Steve's pattern, just had to try it. It is not finished off yet, just finished putting it together, but had to share. I cut 2 at once, using a #0/2 blade.
So please excuse some fuzzies, which I only saw on the pic. Will post again once the finishing touches have been put on.
David

Title: Re: Steve's mininativity
Post by: tux_linux on November 14, 2011, 06:50:37 pm

nice. It's a bit late, otherwise I would have made some from this.

Title: Re: Steve's mininativity
Post by: DWSudekum on November 14, 2011, 08:10:45 pm

Excellent!  I have this in my to cut list as well.  Thanks for sharing it with us.

DW

Title: Re: Steve's mininativity
Post by: newfie on November 14, 2011, 08:22:51 pm

looks nice David thanks for sharing

Title: Re: Steve's mininativity
Post by: Marshall on November 14, 2011, 09:16:07 pm

It's a mighty fine job .....would like to see the final finished product ........

Title: Re: Steve's mininativity
Post by: dgman on November 14, 2011, 09:19:36 pm

Very nice David!

Title: Re: Steve's mininativity
Post by: Russ C on November 14, 2011, 09:27:42 pm

Looks great David, nick work.  :)

Title: Re: Steve's mininativity
Post by: wombatie on November 15, 2011, 12:21:24 am

Excellent work David.

Marg

Title: Re: Steve's mininativity
Post by: frankorona on November 15, 2011, 09:05:03 am

Very nice job.

Title: Re: Steve's mininativity
Post by: bettyswood on November 15, 2011, 01:58:58 pm

He has an update to the little house on this one....Take a peek, both are nice.

Title: Re: Steve's mininativity
Post by: glenn wouters on November 15, 2011, 02:44:53 pm

Nice work David
Great job!

Glenn, Belgium