Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: Danny on November 14, 2011, 04:32:18 pm

Title: Please for a Horse Pattern. :+}
Post by: Danny on November 14, 2011, 04:32:18 pm

Have a potential customer requesting me cut a 8x10 portrait of a Horse.

She purchased the Horse design that Steve did and was in love with it, but she has two grand daughters (horse lovers) and wanted to give them each a picture. 

The portrait below is Steves....Could our designers make me a pattern simular to this?  Thanks in Advance....  Danny  :+}

Title: Re: Please for a Horse Pattern. :+}
Post by: wsmith0896 on November 14, 2011, 05:47:40 pm

I just posted one for you Danny.

Title: Re: Please for a Horse Pattern. :+}
Post by: Danny on November 14, 2011, 06:33:40 pm

Blush....Blush....  wsmith my friend I can not locate your pattern.  HELP....
              Danny  :+(

Title: Re: Please for a Horse Pattern. :+}
Post by: Danny on November 14, 2011, 06:36:22 pm

Oh Oh....  Found it.  LOL....  Duh again.... LOL  That is a GREAT pattern.
     Was hoping for a STALLION like Steves with his hoofs a strudding. 
         Have been following you and you are a Good Designer....  Danny :+}

Title: Re: Please for a Horse Pattern. :+}
Post by: tux_linux on November 14, 2011, 06:59:18 pm

I have recently cut this one. Made some candle trays with it.

Title: Re: Please for a Horse Pattern. :+}
Post by: Dav on November 14, 2011, 07:18:43 pm

steve has a nice one in his catalog that charlie did called charlies horse

Title: Re: Please for a Horse Pattern. :+}
Post by: Gabby on November 16, 2011, 12:10:08 am

Quote from: Dav on November 14, 2011, 07:18:43 pm

steve has a nice one in his catalog that charlie did called charlies horse

You can see it in the gallery, titled Stud Hoss.
Gabby