Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Marshall on October 29, 2011, 09:40:13 am

Title: Daughter-in-law's name plate
Post by: Marshall on October 29, 2011, 09:40:13 am

Made this name plate this week and finally put the last coat of spray Deft Satin Lacquer on it . I made it out of Cherry and I usually make these out of pine and I forget how hard that cherry is until I use it once in a while . This will be part of her Christmas present and I hope she likes it .........any comments are welcome ..........MB ...........

Title: Re: Daughter-in-law's name plate
Post by: Russ C on October 29, 2011, 10:00:50 am

Looks great Marshall, nick work.  :)

Title: Re: Daughter-in-law's name plate
Post by: newfie on October 29, 2011, 10:14:06 am

nice work Marshall thanks for sharing

Title: Re: Daughter-in-law's name plate
Post by: DWSudekum on October 29, 2011, 10:15:02 am

Nicely done Marshall.  Thanks for sharing it with us.


DW

Title: Re: Daughter-in-law's name plate
Post by: Spartan scroller on October 29, 2011, 11:10:05 am

Should look great on her desk Marshall. What thickness cherry and what size blade did you use?

Terry

terrysscollshoppe.blogspot.com (http://terrysscollshoppe.blogspot.com)

Title: Re: Daughter-in-law's name plate
Post by: dgman on October 29, 2011, 11:12:23 am

I love working with Cherry Marshall! That came out very nice. I'm sure it will be appreciated!

Title: Re: Daughter-in-law's name plate
Post by: Intarsia92 on October 29, 2011, 11:28:21 am

Very nice Marshall, Hard woods, like Cherry, look so much richer than pine. She'll love it.

Title: Re: Daughter-in-law's name plate
Post by: Dawie on October 29, 2011, 12:16:35 pm

Looks super Marshall.
David

Title: Re: Daughter-in-law's name plate
Post by: Tim2beupinAz on October 29, 2011, 02:32:49 pm

nice work.

Title: Re: Daughter-in-law's name plate
Post by: Marshall on October 29, 2011, 05:37:28 pm

Quote from: Spartan scroller on October 29, 2011, 11:10:05 am

Should look great on her desk Marshall. What thickness cherry and what size blade did you use?

Terry

terrysscollshoppe.blogspot.com (http://terrysscollshoppe.blogspot.com)

         Terry : 3/4" cherry and I used a fd no. 5 reveres blade I think ........

Title: Re: Daughter-in-law's name plate
Post by: wombatie on October 30, 2011, 01:36:36 am

Very nice work.

Marg

Title: Re: Daughter-in-law's name plate
Post by: frankorona on October 30, 2011, 11:09:00 am

Beautiful cut letters, looks great.

Title: Re: Daughter-in-law's name plate
Post by: glenn wouters on October 30, 2011, 02:09:18 pm

Looking good, nice cut.

Glenn