Scrollsaw Workshop Community -Please register to enable posting.
General Category => Pattern Requests. => Topic started by: GrayBeard on July 25, 2011, 03:52:08 pm
-
I did it!
I have been commissioned to make a number of different 'baseball' related plaques for the gift shop at the Rascals ballpark!
Now I need a good clean pattern of this logo that I can do in various sizes from about 3" high to up to 10" high.
Any of my 'designing friends' care to give me a hand.
-
Are you wanting it in one piece or in layers?
-
Initially as a single item to cut into the plaques with other art. These would therefore have to be rather small, no more than about 3" tall.
Eventually i would like to maybe do a fancy layered 12" or so pattern for the wall in the president's office.
~~~GB~~~
-
Not sure what you want, but, we made a cuttable pattern and cut them on 1/2" oak, rounded the edges and glued on a 1/8" BB ply backer painted black AND thier colors where needed. Just an idea.
Ron
-
I'm working on a layered version
-
Contact me artistic_cowboy30@yahoo.com to pick up these in full size. I did one for each color of the logo. Black backer, Black-and-White for the white areas, Tan for the border and bat, Gray for the areas in the ears,eye and the arm ...and Red for the "RC". I also surrounded it with a square so all of the layers can be lined up.
(http://i206.photobucket.com/albums/bb136/artistic_cowboy30/RC-Group.gif)
-
My sincere THANKS to you both!
The patterns are fantastic and gives me plenty to work with.
Now to get my fanny out in the shop and get busy...have to have a couple samples ready to take to the game on Wed.!
Your work is MUCH appreciated~
~~~GrayBeard~~~
-
Just like magic, Huh GrayBeard?
-
Dan, it just blows my mind every time our "Prolific Pattern Purveyors" come thru like that!
I would have been more than happy to get something in a few days.
Our guys are the absolute TOPS!
~~~GB~~~