Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: gtxmag440 on June 14, 2011, 04:40:02 pm

Title: craftsman 16 in. scroll saw hit to run
Post by: gtxmag440 on June 14, 2011, 04:40:02 pm
My craftsman scroll saw will not srart unless I give it a good wack. Then it will start and run a few seconds then stop. I dont think its the motor because it runs those few seconds. Everything cord switch etc. looks good. Its out of warranty. Is there anything else I can do. I cant afford another saw. Thanks for any help.
Title: Re: craftsman 16 in. scroll saw hit to run
Post by: dgman on June 14, 2011, 07:59:50 pm
Welcome to the forum! Chances are the switch has saw dust in it. Try blowing it out with compressed air. If that does not work, you will have to replace the switch.
Title: Re: craftsman 16 in. scroll saw hit to run
Post by: Chachi on June 15, 2011, 01:11:15 am
When Mine did it I tore it apart and found out the hot wire (red) broke off the Veriable speed button just enough that it would come on start cutting and go off mid cut, so check that it could be your problem as well.... Good luck to you
Title: Re: craftsman 16 in. scroll saw hit to run
Post by: tux_linux on June 15, 2011, 07:12:47 am
yeah, check the switch and the wires. Be careful! Electricity is just nice from a certain distance.
Good chance to figure out the foot switches.

regards
Torsten
Title: Re: craftsman 16 in. scroll saw hit to run
Post by: gtxmag440 on June 23, 2011, 01:12:15 pm
I just got a new switch. When I installed it the saw started right up. It ran for a few seconds then quit again. I hit it again it ran a bit then compleatly stopped. Anything else I can try.
Title: Re: craftsman 16 in. scroll saw hit to run
Post by: Graywolf on July 04, 2011, 04:28:46 pm
Could be the brushes in the motor, you could take the motor in and get it checked out.
Title: Re: craftsman 16 in. scroll saw hit to run
Post by: tux_linux on July 04, 2011, 06:41:27 pm
hmm, wiggle the cables, could be one of the cables.
The plugs to the switch are ok?

Again, be careful. It's electricity. Non visible until it's too late.