Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: dgman on April 03, 2011, 12:30:24 am

Title: Ying Yang Dragon
Post by: dgman on April 03, 2011, 12:30:24 am

Can someone make this into a cuttable pattern to fit into a 4x4" square?

Title: Re: Ying Yang Dragon
Post by: Bill P on April 03, 2011, 12:53:46 am

That would be awesome as an inlay or intarsia project!

Bill

Title: Re: Ying Yang Dragon
Post by: Gabby on April 03, 2011, 03:14:30 am

DG
It looks like a good pattern as it is, I'd think it would just be a matter of sizing to print what you want.
Gabby

Title: Re: Ying Yang Dragon
Post by: grampa on April 03, 2011, 09:42:34 am

Hi Dan, Here you go, hope its ok.....Paul

Title: Re: Ying Yang Dragon
Post by: julief on April 03, 2011, 09:53:30 am

That is too cool, Grandpa.

Title: Re: Ying Yang Dragon
Post by: dgman on April 03, 2011, 10:15:18 am

Thanks Grampa! It just like magic, I made my request last night, and wake up this morning and there it is! Thank you so much!

Title: Re: Ying Yang Dragon
Post by: Gabby on April 03, 2011, 11:56:58 am

Right on 4" by 4" Grampa, what did it take you 15 seconds?
Gabby

Title: Re: Ying Yang Dragon
Post by: GrayBeard on April 04, 2011, 04:34:51 pm

That is the beauty of having a Pattern Purveyor that lives a few 'time zones' to the East!

Great job again, Grampa Paul!

~~~GB~~~

Title: Re: Ying Yang Dragon
Post by: Merlin on April 04, 2011, 05:07:48 pm

Thanks Paul that is truly wonderful pattern, now to find the time to cut it.

***Merlin***

Title: Re: Ying Yang Dragon
Post by: Oges on April 06, 2011, 08:33:13 pm

I had that picture saved to make a pattern from one day, guess I dont need to do it now. Great pattern Paul  :)