Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: wardch on March 27, 2011, 01:42:23 am

Title: Hegner and Spiral Blades
Post by: wardch on March 27, 2011, 01:42:23 am

I have a Hegner 22V that I've own for 18 years.  I'm wondering if I have been using it wrong for all these years.  Found out something today while using Spiral blades. There is a screw on top of the upper clamp that holds the clamp still.  I thought this was just used when you were changing blades.  I have always screwed it down to change the blade then backed it off about 1/4 turn.   I thought this was mention in the manual which i can't find.  Anyway When using the spirals I left the screw turned so the clamp wouldn't move.  Unbelievable.  The spirals worked 100% better.  So just wondering does anyone else just leave the screw tightened against the upper clamp?  All the time.  Even with flat blades.   

Thanks,

Chris

Title: Re: Hegner and Spiral Blades
Post by: Waddawood on March 27, 2011, 03:36:06 am

I only use spirals and have a hegner also and have always kept it screwed down on the top clamp

Title: Re: Hegner and Spiral Blades
Post by: wardch on March 27, 2011, 08:04:43 am

Thanks Charlie,   I'm going to have to try this with the Flat blades also. See what difference there is.

Title: Re: Hegner and Spiral Blades
Post by: Intarsia92 on March 27, 2011, 09:36:31 am

I keep mine screwed tight when doing fret work, regardless of type of blade.