Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: keidiag on April 24, 2010, 11:10:53 pm

Title: Scroll Saw Table Tilt - 2
Post by: keidiag on April 24, 2010, 11:10:53 pm

For some strange reason the link to my photo stopped working. Here it is again. Sorry about that...Keith


(http://i408.photobucket.com/albums/pp168/keith-scrolls/Scroll-Saw/IMG_1625.jpg)

Title: Re: Scroll Saw Table Tilt - 2
Post by: cherie on April 25, 2010, 10:12:13 am

That is nice.  Mine is tilted only about 1 inch.  But even a little helps the back and hands.

Title: Re: Scroll Saw Table Tilt - 2
Post by: northie66 on April 25, 2010, 10:44:43 am

So the back is 3 inches higher than the front?  Is that right?  And that makes for a 5 degree tilt?

Title: Re: Scroll Saw Table Tilt - 2
Post by: keidiag on April 25, 2010, 11:09:03 am

Janet

The 3" rise at the back will give an angle closer to 6 degrees. I find it just about perfect. Someday I'll try a rise of 4" and see how that works out.

Keith