Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: grampa on December 06, 2010, 10:52:05 am

Title: I managed to get a bit of shop time
Post by: grampa on December 06, 2010, 10:52:05 am

I got a order for a kitten, it didn't turn out to bad considering I could not feel my fingers
Soon be getting a warm shop.........Paul ;D

Title: Re: I managed to get a bit of shop time
Post by: dgman on December 06, 2010, 11:17:56 am

That's so cute Grampa!

Title: Re: I managed to get a bit of shop time
Post by: dunk on December 06, 2010, 11:19:35 am

Adorable.  Bout time you got some shop time even if you did have to wear mittens to cut yer kitten.

Title: Re: I managed to get a bit of shop time
Post by: julief on December 06, 2010, 11:24:33 am

Really nice, Paul.

Title: Re: I managed to get a bit of shop time
Post by: GrayBeard on December 06, 2010, 11:50:33 am

That is very 'cute'!

Might have to try that finishing technique!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

RE: COOOOOLD Shop!
I just went out and turned on the heater so I can get busy today. Was 41? F in the garage. Placed my small electric heater right under the saw to 'warm' the table and the propane heater is going full blast on high. Should be a workable temp in about an hour.

Weather service says it 'may' get close to 60? today and the rest of the week. Additional costs of work for propane are a pain! I'd rather be buying WOOD!!!!!

~~~GB~~~

Title: Re: I managed to get a bit of shop time
Post by: termite on December 06, 2010, 07:45:21 pm

i like the extra cuts & name. they add to  the picture. good job

Title: Re: I managed to get a bit of shop time
Post by: boxmaker on December 06, 2010, 08:56:10 pm

It turned out great Grampa, I hope you get some heat soon.

                                                                 Mark

Title: Re: I managed to get a bit of shop time
Post by: Marcellarius on December 07, 2010, 11:11:39 am

very nice job Paul!

Title: Re: I managed to get a bit of shop time
Post by: MadHatter on December 07, 2010, 12:14:31 pm

wonderful job.  :)

Title: Re: I managed to get a bit of shop time
Post by: Russ C on December 07, 2010, 07:22:58 pm

Nice job, I like it. Thanks for posting the pictures  8)